Court Line Marking
Regulation lines that stay square, readable, and correctly measured from the first day of play.
What Goes Wrong
The difference between a court that plays correctly and one that causes disputes comes down to measurement discipline before the first drop of paint.
Lines painted without diagonal verification drift out of square, making sideline and baseline calls inconsistent across the court.
Chalk lines are snapped and diagonal measurements confirm a square layout before masking tape is placed anywhere.
A non-volley zone placed at 6 feet instead of 7 feet changes the game, and the error is invisible until someone measures it.
The non-volley zone line is measured from the net on both sides and verified again after paint dries, not just before.
Applying line paint over a dusty, coated, or porous surface causes peeling within weeks, especially on Tampa’s sun-baked asphalt.
Adhesion and porosity are checked during the site assessment so the right paint is selected for the specific surface condition.
Lines wider or narrower than 2 inches make close calls harder to judge and signal a court that was not laid out to standard.
Masking tape sets a consistent 2-inch boundary for every line before paint is applied, keeping width uniform across the full court.
Scope of Work
From a first-time layout on a new slab to re-marking a faded HOA court, the work follows the same measurement-first sequence.
Full baseline, sideline, centerline, and non-volley zone layout on a fresh concrete or asphalt surface, painted to the 2-inch standard.
Existing lines are assessed, old boundaries are re-measured, and fresh paint is applied where fading or peeling has made lines hard to read.
Tennis or multi-sport courts are re-laid with pickleball dimensions, including service boxes and the 7-foot non-volley zone on each side.
Multi-court community setups are measured and marked in sequence, with consistent line width and color across every court on the property.
Outer boundary lines measured and painted to regulation.
Kitchen line set at exactly 7 feet from the net.
Interior lines dividing each side of the court.
Corner-to-corner check before any paint is applied.
Why Choose Us
Local knowledge, a written scope, and a process built around accountability from first contact to final verification.
Every scope item is listed separately in writing before a single line is masked or painted.
A local court builder visits to check surface condition, drainage, and layout space before the estimate is written.
Paint is chosen for UV resistance and surface porosity, accounting for Tampa’s year-round sun and high foot traffic.
Our partners regularly mark shared-use courts across Tampa Bay HOA and active adult communities.
After marking, you receive a maintenance schedule so lines are re-marked before they become unreadable.
The Process
01
Share your surface type, court use, and any HOA constraints so a local builder can schedule an assessment at no obligation.
02
You receive an itemised estimate covering layout, masking, paint, and any prep work needed before lines are applied.
03
The builder measures, masks, paints, and verifies every line to regulation before the court is handed back for play.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Re-striping a single court | $300-$800 |
| Striping for multiple lines or shared-use layout | $800-$1,500 |
| Full line marking package | $1,500-$3,000 |
Share your surface, location, and any HOA constraints. We’ll arrange a site visit and a written itemised estimate at no obligation.